![]() ![]() With twisted pair cabling (as used for ethernet, there are other varieties for other systems that are not applicable here) with each cable providing a single point-to-point connection, generally between a computer and a hub or a switch. This was replaced many, many years ago, by twisted pair cables using hubs and switches. Originally, ethernet used coaxial cables with a tap into the cable for each computer. (Exception: the house I grew up in actually had separate runs to each room, though that was in the days before twisted pair ethernet, so it didn't matter much). A single chain through a building is generally cheaper to install (less wire, a lot less labor if installed while the walls are open during construction) than a star configuration, so until home networks became common, that was the standard installation method. The polarity of the wires usually doesn't matter, and the devices could be wired in a star topology (a bunch of cables joined together at one end with a device on each cable on the other end) or chained one device (or more commonly, wall jack for a device to plug in) to the next. ![]() All devices are connected together with a pair of wires. Standard analog telephone service (POTS) could have many devices - telephones, answering machines, fax machines, modems, etc. Assuming that the cable you already have in place is at least Cat 5 (100 Meg., which is arguably enough for typical internet usage), the topology is the next challenge. ethernet) but also on much older types of cables that are not suitable for ethernet at all. ![]() It is recommended that the customer install a surge arrestor in the electrical outlet to which the Communicator is connected.There is a separate issue of the type of cable. You should be at least 36 inches (3 ft.) away from televisions, VCRs, DVD players, personal computers, and other electronic equipment, when you are using the Communicator. Some household appliances and other sources of electromagnetic energy could interfere with the communication between your Communicator and your implanted device. Your communicator should remain connected to a telephone line, ethernet adaptor or cellular adaptor. It is very important that the Communicator remain plugged into the power outlet. Ask your physician if you have questions about any risks with using the Communicator or your implanted device. The Communicator is not for use with any pulse generator other than a Boston Scientific device. It will not work with other patients’ implanted devices and should be used only as authorized by the prescribing physician. The Communicator is designed to work only with the implanted device of the patient for whom it was prescribed. The Communicator may work on other telephone systems, such as Digital Subscriber Line (DSL) and Voice Over IP (VoIP) Internet systems, if those systems provide an analog interface for connecting the Communicator. The Communicator is designed to operate on standard telephone lines like those found in most homes. The Communicator does not provide continuous monitoring. If you are not feeling well, call your physician or 911. The LATITUDE Patient Management system is not intended to assist with medical emergencies. LATITUDE™ NXT Patient Management is a remote monitoring system that gives your health care provider access to your implanted device data. ![]() LATITUDE™ (NXT) Patient Management System ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |